First I started buy removing case screws

After removing case screws set face down and lift back panel easy you well see screws holding led panel

some of the gaps were tight so slimmer driver recommended After all eight screws removed very gently life out back plate and panel

there are ties that need to be cut to disconnect the led panel
once the panel was apart with one plugged in again for a test to see where the noise was , yea the fan it’s toast
as you can see there is a bundle of tied wires so I also had to clip them to remove the fan 

placed light back in case just to be safe till I get parts 

last few pics are on internals , if any suggestions of better power supplies or led drives let me know Cheers
Bloody phone lmao


